K753 HYDRAULIC PISTON SEAL

K753 is a three piece double acting sealing set which consists of one special mixture PTFE profile ring , one X-ring as for main sealing element and an O-ring as energizing element.

PRODUCT ADVANTAGES
• Wide range of temperature and chemicals depending on the o-ring and x-ring material
• Low friction , free of stick-slip
• High sealing effect in applications requiring media separation
• Low gas permeation rate
• Minimum static and dynamic friction coeffcient for a minimum energy loss and operating temperature
• Simple groove design and low axial housing heights

APPLICATION
Accumulators , heavy duty cylinders , presses and machine tools.

MATERIAL		CODE
NBR	70 SHORE A	NB_⁷⁰⁰¹
PTFE		PT_⁶⁰⁰³

OPERATING CONDITIONS

MEDIA

Mineral oils (DIN 51524)

HFA ve HFB

HFC

TEMPERATURE

-30°C +105°C

+5°C +60°C

-30°C +60°C

PRESSURE

≤400 Bar

SPEED

≤2.0 m/sn

Note: The above data are maximum values and cannot be used at the same time.

SURFACE ROUGHNESS	Ra	Rmax
Sliding Surface ØD	≤0.2 μm	≤2.0 μm
Groove Base Ød	≤1.6 μm	≤6.3 μm
Groove Flanks B	≤3.2 μm	≤15 μm
Note: It is recommended to have 50% to 90% of the working surface material contact area value.
INSTALLATION It is recommended to assembly into one piece piston with special assembly tool (See section; Hydraulic Sealing Elements General Installation Information). It is very important that the assembly tools must be of soft material and have no sharp edges. Before installation the sealing element must be oiled with system oil. NOTES It is recommended to use with minimum two piston guide rings in long stroke cylinders , minimum one guide ring in short stroke and low radial loaded cylinders. For special applications that require high temperatures or resistance to chemicals , piston seal is being manufactured with special mixture PTFE and FKM material. The permissible sealing gap values of K753 piston seal is given in the below table.

PERMISSIBLE SEALING GAP

B (mm)	Smax (mm)
	150 Bar	250 Bar	400 Bar
0.25	0.15	0.10	4.2
6.3	0.30	0.20	0.15
8.1	0.30	0.20	0.15
9.5	0.50	0.25	0.20

Note: The largest sealing gap value occurring on the non-pressurized side of the seal does have a vital importance for the function of the seal and in this respect it is quite important to use the S value lower than the above indicated numbers.


	ชื่อสินค้า	ราคา	จำนวน	OD	ID	Thickness	Thickness L2	Thickness2	Type	Part NO	Material
	K753 PISTON SEAL 16X5X4.2	฿332.00		16	5	4.2	-	-	K753 PISTON	K753-016	NBR,PTFE

Account

Account

เพื่อความสะดวกในการค้นหาสินค้า ลูกค้า สามารถกรอกข้อมูล ในช่องต่างๆ ได้ทันที