APPLICATION Short stroke pneumatic cylinders and valves.
70 SHORE A
Prepared , dried and de-oiled compressed air
-30°C +105 °C
Note: The above data are maximum values and cannot be usedat the same time.
Sliding Surface ØD
Groove Base Ød
Groove Flanks B
INSTALLATION K65 can be snapped by hand into the housing grooves provided. In case of using an assembly tool make sure that it is of soft material and have no sharp edges. Before installation the sealing element must be oiled with system oil. Special lubrication should be used on the sliding surface in case of having dried media.
NOTES For special applications that require high temperatures , K65 can be produced in FKM material.
At pressure range <1 bar vent hole is recommended; however single-acting sealing function is guaranteed at this condition.